/*===================================================================*/
 /* NRDF D1659 Data No.8                                              */
 /*===================================================================*/
 /* Bibliography                                                      */
 /*===================================================================*/
 \\BIB,8;
 D#=D1659;
 TITLE=/Two deformation paths in proton-induced fission of 232Th/;
 PURPOSE=/Accurate measurements of complementary fission
          fragmentvelocities in the proton-induced fission of 232th/;
 ATH=(Y.NAGAME'1', I.NISHINAKA'1', K.TSUKADA'1', Y.OURA'1',
      S.ICHIKAWA'1', H.IKEZOE'1', Y.L.ZHAO'2', K.SUEKI'2',
      H.NAKAHARA'2', M.TANIKAWA'3', T.OHTSUKI'4', H.KUDO'5',
      Y.HAMAJIMA'6', K.TAKAMIYA'7', Y.H.CHUNG'8');
 INST-ATH=(2JPNJAE'1', 2JPNTMU'2', 2JPNTOK'3', 2JPNTOH'4', 2JPNNII'5',
           2JPNJPN'6', 2JPNOSA'7', 3KORKOR'8');
      /* '2' Department of Chemistry */
      /* '3' Department of Chemistry */
      /* '4' Laboratory of Nuclear Science */
      /* '5' Department of Chemistry */
      /* '6' Department of Chemistry, Kanazawa University, Kanazawa */
      /* '7' Department of Chemistry */
      /* '8' Department of Chemistry, Hallym University, Chuncheon */
 REF=PL/B;
 VLP=387(1996)26;
 RCTS=232TH(P,FISSN);
 PHQS=(A-DSTRN'9', AVER-KIN-ENGY'10', ENGY-SPEC'11', ENGY-SPEC'12',
       ENGY-SPEC'13', ENGY-SPEC'14', ENGY-SPEC'15');
 /* '9' Heavy fragment mass distribution */
 /* '10' average total kinetic energy */
 /* '11' total kinetic energy distribution (A=126) */
 /* '12' total kinetic energy distribution (A=128) */
 /* '13' total kinetic energy distribution (A=130) */
 /* '14' total kinetic energy distribution (A=132) */
 /* '15' total kinetic energy distribution (A=134) */
 /*===================================================================*/
 /* Experimental Conditions                                           */
 /*===================================================================*/
 \\EXP,8;
 /* 2003-11-22 : Converted, Data converted to EXFOR E1659 and EXFOR
    O0383. */
 RTY=FISSN;
 CHM=ELM;
 PHYS-FORM=SLD;
 THK-TGT=0.07MG/CM**2;
 BAC=C;
 THK-BAC=0.02MG/CM**2;
 POL-TGT=0%;
 ALGN-TGT=0%;
 ACC=VDGT;
 INST-ACC=2JPNJAE;
 BEAM-INTNSTY=500[800NA;
 POL-PRJ=0%;
 DET-PARTCL=X'16';
 /* '16' Fission Fragments */
 COINC=NO;
 ANT-COINC=NO;
 DET-SYS=(MCPLT'17',SBD'18',MCPLT'19',PPAC'20');
 /* '17' Placed at theta(lab)=50deg. Used as start and stop ToF
         (ToF1) detectors with carbon foil (30-micro gram/cm2). The
         flight path and solid angle are 55 cm and 0.17 msr,
         respectively. */
 /* '18' Placed behind the stop MCPD. Used for stop and energy
         signals. */
 /* '19' Placed at theta(lab)=130deg. Used to deliver start ToF
         signal (ToF2) to detect complementary fragments of ToF1. The
         flight path and solid angle are 50 cm and 32 msr,
         respectively. */
 /* '20' Used to deliver stop signal of ToF (ToF2). */
 ERS-DET=<2.5MEV'21';
 /* '21' for total kinetic energy */
 CALB-DET=/ Velocity calibration was performed using the 240 MeV 127I
            beam to bombard thin (70-100 micro-gram/cm2) calibration
            targets, natAg, natIn, natSb, and 209Bi. Each target was
            evaporated on 30 micro-gram/cm2 thick carbon foils. The
            recoil nuclei and the elastically scattered 127I ions were
            detected with the present ToF system. /;
 /* Experimental Method:
    - Time-of-flight (To measure fission fragment velocities)
    - Beam current integrated (The average beam current was 500-800
      nA.)
 RCT=232TH(P,FISSN);
 PHQ=ENGY-SPEC'52';
 /* '52' total kinetic energy distribution (A=128) */
 INC-ENGY-LAB=14.7MEV;
 /*===================================================================*/
 /* Descriptive Parameters                                            */
 /*===================================================================*/
 \\DATA,8;
 INC-ENGY-LAB=14.7MEV;
 EMT=X'53';
 /* '53' Fission fragments */
 A=128;
 DELTA-TOT-KIN-ENGY=0.5MEV'54';
 /* '54' Data-point reader uncertainty */
 DELTA-COUNTS=0.5ARB'55';
 /* '55' Data-point reader uncertainty */
 /*===================================================================*/
 /* Data Table                                                        */
 /*===================================================================*/
 \DATA;
 TOT-KIN-ENGY'56' COUNTS'57'
 (MEV) (ARB)
       110.5        0.4
       112.1        0.4
       114.7        0.4
       117.3        0.8
       118.3        0.4
       120.2        0.3
       123.8        0.3
       125.5        1.5
       127.1        1.5
        130.        1.9
       132.3        3.4
        134.        5.8
       135.9        4.6
       138.2         7.
       140.5        8.2
       142.2       13.3
       144.5       12.5
       146.6       19.6
       148.3       26.7
       149.6       29.9
       152.5       46.1
       153.9       59.2
       156.5       54.8
       157.8       55.2
       160.6       67.9
       162.1       64.3
       164.4       60.7
       166.6       79.3
       168.5       73.8
       170.1        71.
       171.9       63.5
        174.       50.8
       176.8        67.
        178.       53.9
       180.6       52.3
       182.6       36.1
       184.5       27.7
        187.       24.9
       189.5       16.6
       191.4       10.3
       192.7        8.3
       194.6        4.3
       196.5        5.5
       199.4        3.1
 \END;
 /*===================================================================*/